Sligo Systems’ pumps come with a rubber molded cable entry providing superior sealing.  This, in conjunction with an anti-wick block, prevents any moisture from entering the motor compartment due to any accidental knicks or cuts in the cable jacket.  The entry’s limited-compression design allows the power cable to be reused after a pump overhaul cycle. This represents a significant cost savings for longer cable runs. 

Expect Your Motor Leads To Be Reusable

Sligo Systems’ level sensors are externally mounted and can be quickly and easily replaced without disassembling the pump – Saving labor expense and reducing risk of damaging the new sensor lead.

Expect Your Level Sensor to Be Easily Accessible

Sligo Systems’ level sensors are externally mounted and can be quickly and easily replaced without disassembling the pump – Saving labor expense and reducing risk of damaging the new sensor lead.

Expect Your Level Sensor to Be Easily Accessible

Sligo Systems’ Side-slope rugged riser skids simplify pump installation utilizing polymer runners designed to negotiate pipe seams and imperfections with ease.  Unlike wheeled designs, there are no damage prone moving parts. 

Expect Your Pumps to Install Simply With No Moving Parts

Sligo Systems’ pumps are based on designs for raw sewage and mine dewatering application.  They can handle anything typically found in a sump. Biogrowth, entrained silt or even rocks will not affect the long term performance and reliability of the pump.

Expect Your Pumps to Handle Solids Without Damage

Whether caused by sensor failure or operator error, Sligo Systems’ pumps are designed to continue operating for at least 24 hours without damage.

Expect Your Pumps to Run Dry Without Damage